Vidikron VP-6000a Guia Do Utilizador
Vidikron PlasmaView Owner’s Operating Manual
51
PRE
L
IMINAR
Y
5.1
Cleaning
Cleaning
Regular cleaning will extend the life and performance of the PlasmaView. Before cleaning, be
sure to unplug the power cord from the power outlet.
sure to unplug the power cord from the power outlet.
Cleaning the Display Panel
Body and Remote Control
Body and Remote Control
Do not under any circumstances use solvents such as benzene or thinner to clean the
PlasmaView. Doing so may cause deterioration or peeling of paint from the display or remote
control unit.
PlasmaView. Doing so may cause deterioration or peeling of paint from the display or remote
control unit.
Wipe the display and remote control gently with a soft cloth. In the case of excessive dirt
buildup, dampen a soft cloth with a diluted neutral cleaning detergent and after wringing
the cloth thoroughly, wipe the component and then dry it with a dry soft cloth.
buildup, dampen a soft cloth with a diluted neutral cleaning detergent and after wringing
the cloth thoroughly, wipe the component and then dry it with a dry soft cloth.
Cleaning the Screen
After dusting, wipe the screen gently using the supplied cleaning cloth or another soft cloth
(cotton, flannel etc.). Do not use tissue or a rough cloth. The screen surface is easily scratched;
do not rub it or hit it with a hard object.
(cotton, flannel etc.). Do not use tissue or a rough cloth. The screen surface is easily scratched;
do not rub it or hit it with a hard object.
If you clean the surface of the screen with a wet cloth, water droplets on the surface may
enter into the product and cause a malfunction.
enter into the product and cause a malfunction.
Cleaning the Vents
As a general rule, use a vacuum cleaner about once a month to clean the vents on the rear
panel of the display of dust buildup (set the vacuum cleaner to its weakest setting when
doing this). If not removed, accumulated dust can cause the internal temperature to increase,
resulting in possible breakdown or fire.
panel of the display of dust buildup (set the vacuum cleaner to its weakest setting when
doing this). If not removed, accumulated dust can cause the internal temperature to increase,
resulting in possible breakdown or fire.
5.2
Troubleshooting Tips
Troubleshooting Tips
Table 5-1 provides some general guidelines for troubleshooting problems you may
encounter with the PlasmaView. If the suggested solutions fail to resolve the problem or if
you encounter an issue not described here, please contact your Vidikron dealer or Vidikron
Technical Support.
encounter with the PlasmaView. If the suggested solutions fail to resolve the problem or if
you encounter an issue not described here, please contact your Vidikron dealer or Vidikron
Technical Support.
5
Maintenance and Troubleshooting
Table 5-1. Troubleshooting Chart
Symptom
Possible Cause(s)
Solution
The display does not turn on
after initial installation.
after initial installation.
•
The PlasmaView is not
plugged in or the AC outlet
is not active.
plugged in or the AC outlet
is not active.
•
The remote control
batteries have run out.
batteries have run out.
•
Ensure that the PlasmaView
is plugged in and that the
AC outlet is active.
is plugged in and that the
AC outlet is active.
•
Replace the batteries.
The display is on, but there is
no picture or sound.
no picture or sound.
•
Incorrect source selection.
•
Source component is not
turned on.
turned on.
•
Source component is
connected incorrectly or
not at all.
connected incorrectly or
not at all.
•
Select the correct source.
•
Turn on the source
component.
component.
•
Check video connections to
source component.
source component.