Toshiba 42L6200U Manual Do Utilizador

5

38)

Never spill liquids or push objects of any kind into 
the TV cabinet slots.

39) During a lightening storm, do not touch the 

connecting cables or product.

40) For added protection of your TV from lightning and 

power surges, always unplug the power cord and 
disconnect the antenna from the TV if you leave 
the TV unattended or unused for long periods of 
time.

41) Always unplug the TV to completely disconnect 

from mains power. When the TV is turned off using 
the on/off switch, it is not completely disconnected 
from power and a minute amount of current is still 
consumed.

42) During normal use, the TV may make occasional 

snapping or popping sounds. This is normal, 
especially when the unit is being turned on or off. If 
these sounds become frequent or continuous, 
unplug the power cord and contact a Toshiba 
Authorized Service Provider.

43)

Never strike the screen with a sharp or heavy 
object.

44) • The LCD screen of this product can be damaged 

by ultraviolet radiation from the sun. When 
selecting a location for the television, avoid 
locations where the screen may be exposed to 
direct sunlight, such as in front of a window.

• Never touch, press, or place anything on the 

LCD screen. These actions will damage the LCD 
screen. If you need to clean the LCD screen 
follow the instructions (in item 

Never attempt to service the TV yourself. Opening 
and removing the covers may expose you to 
dangerous voltage or other hazards. Failure to 
follow this WARNING may result in death or 
serious injury. Refer all servicing not specified in 
this manual to a Toshiba Authorized Service 
Provider.

45) If you have the TV serviced: 

• Ask the service technician to use only 

replacement parts specified by the 
manufacturer.

• Upon completion of service, ask the service 

technician to perform routine safety checks to 
determine that the TV is in safe operating 
condition.

Observe the following safety precautions:
1) Read and follow the pedestal assembly 

instructions included with the pedestal.
CAUTION: Before beginning pedestal assembly, 
carefully lay the front of the LCD Panel face down 
on a flat, cushioned surface such as a quilt or 
blanket. Leave the bottom of the unit protruding 
over the edge of the surface and assemble the 
pedestal as indicated below.
Note: Extreme care should always be used when 
attaching the pedestal stand to avoid damage to 
the LCD panel.

2) Place the TV on a sturdy, level surface that can 

support the weight of the TV. 

3) Be sure to secure the TV to a wall, pillar, surface, 

or other immovable structure see item 

for additional details.

If you decide to wall mount your LED TV, always use a 
wall bracket Listed by an independent laboratory 
(such as UL, CSA, ETL) that is appropriate for the size 
and weight of the TV (see page 2):
1) CAUTION: Two people are required for 

installation.

2) Unplug and remove any cables and/or other 

component connectors from the rear of the TV.

3) Remove the screws of the VESA Mounting Pattern 

show in the table below.
CAUTION: Do not use the screws removed from 
the back cover to attach the wall mount bracket to 
the TV.

4) Always use the screws supplied or recommended 

by the wall mount manufacturer.

5) Follow the instructions provided with your wall 

bracket. Before proceeding, make sure the 
appropriate bracket(s) are attached to the wall and 
the back of the TV as described in the instructions 
provided with the wall bracket.

6) After attaching the appropriate bracket(s) to the 

wall and the back of the TV, remove the pedestal 
stand from the TV, as described below.

7) VESA Mounting Pattern

42L6200U

400x400 mm

M6

47L6200U

400x400 mm

M6

55L6200U

400x400 mm

M6

47L7200U

400x400 mm

M6

55L7200U

400x400 mm

M6

(unit in mm)