Pioneer VSX-D909S Manual Do Utilizador

This switch moves the input fed to the receiver between analog and digital sources. You need to take special
care to switch to the appropriate input, when necessary. For example, the switch would have to be on DIGITAL
to use DOLBY DIGITAL or DTS surround sound but it would have to be on ANALOG to record to the analog out
jacks on the receiver. The default setting is AUTO (priority is given to a digital signal, if there is one).

Each press switches the signal in the order below:

• In the AUTO setting, SIGNAL SELECT chooses the signal in the following order: DIGITAL, ANALOG.
• If the Digital-In Select (see page 31) choices are set to OFF, the SIGNAL SELECT will default to ANALOG.
• Because the audio from a karaoke microphone and LD recorded with analog audio only is not output from

the digital output, set SIGNAL SELECT to ANALOG.

• This receiver can only playback Dolby Digital, PCM (32kHz, 44kHz, 48kHz, and  96kHz), and DTS digital

signal formats. If you have some equipment that outputs digital audio in a format other than these you'll
have to connect and playback via the receiver's analog inputs (make sure that SIGNAL SELECT is set to
ANALOG).

• When an LD or CD with DTS is played back with the SIGNAL SELECT set in ANALOG, digital noise caused

by playing back the DTS directly (with no decoding) is output. To prevent noise, you need to make digital
connections (See pages 13 and 14) and set SIGNAL SELECT to DIGITAL or AUTO.

• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with

your DVD player.

memo

Î

¶

8

7

3

1

¡

4

¢ 

When a DTS signal is
input.

When a Dolby Digital
signal is input.

AUTO

ANALOG

DIGITAL

VSX-D909S