Toshiba 42L6200U 47L6200U 55L6200U 47L7200U 55L7200U Manual Do Utilizador

66

Press the ( /  arrow) buttons to select Home. 

Press the OK button.

This setting configures the antenna input source for the 
ANT/CABLE terminal.

Press the MENU button.

Select SETTINGS, SETUP, and then ANT/CABLE In.

Select Antenna or Cable and press Next.

Select Cable and press Next.

If you do not want to scan channels, you do not need to make a 
selection for ANT/CABLE. Select Next and press OK to skip this 
step.

Select Start Scan.

After scanning is complete, the auto tuning results screen will 
appear. 

Press OK or EXIT.

To make sure your TV stops only on the channels you want when 
you press the CH Up/Down arrow buttons on the remote control or 
the control panel, store those channels in the TV’s memory.

You must set up the antenna/cable input source first. See 

You can set up the TV to detect all active channels in your area and 
store them in its memory. Then you can manually store or skip 
individual channels from memory.

Cable

Note: If you select Cable, auto tuning deletes previously stored 
channels from memory.

This setup requires some time, but you do not need to repeat the 
setup unless your cable TV service’s lineup changes significantly.