Toshiba 23HLV84 Manual Do Utilizador

2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by
connecting an amplifier equipped with a digital audio input and speaker
system (right and left front speakers).

Before you connect this TV/DVD to your PC, change the adjustment of
your PC’s Resolution and Refresh rate. See “Monitor Display modes”
at right.
Connect one end of a (male to male) VGA cable to the video card of
the computer and the other end to the VGA connector PC at the back
of the TV/DVD. Fix the connectors firmly with the screws on
the plug. In case of a Multimedia computer, connect the audio cables
to the audio outputs of your Multimedia computer and to the AUDIO L
and R connectors of the PC IN jacks of the TV/DVD.
Press INPUT and number button 5 on the remote control to select PC
mode.
Switch on the computer. The TV/DVD can be operated as the
computer monitor.

Monitor Display modes
MODE

Resolution

Refresh rate

VGA

640x480

60Hz

SVGA

800x600

56.3Hz

SVGA

800x600

60.3Hz

XGA

1024x768

60Hz

Amplifier equipped with a

Digital audio input

To COAXIAL
type digital
audio input

To COAXIAL
DIGITAL AUDIO
OUT

You will need:
• one VGA cable

To PC

You will need:
• one coaxial cable

• PCM audio is limited to DVD or CD

playback.

• Connect the COAXIAL DIGITAL AUDIO

OUT jack of the TV/DVD to the “COAXIAL”
input of a Receiver or Processor.

• Refer to the owner’s manual of the

connected equipment as well.

• The output sound of the TV/DVD has a wide

dynamic range. Be sure to adjust the
receiver’s volume to a moderate listening
level. Otherwise, the speakers may be
damaged by a sudden high volume sound.

• Turn off the amplifier before you connect or

disconnect the TV/DVD’s power cord. If you
leave the amplifier power on, the speakers
may be damaged.

Press INPUT again.

• The current signal source does not display

when you return to TV mode.

• The form of a character of OSD in PC mode

differ from TV or DVD mode.

J5P00101A(E)P11-21

8/12/04, 11:24 AM

20