Toshiba 32L4300 Manual Do Utilizador

66 

Press the p/q (arrow) buttons to select Antenna or Cable.

Press the OK button.

Select Start Scan.

After scanning is complete, the auto tuning results screen will 

appear.

Press the OK or EXIT button.

To make sure your TV stops only on the channels you want when you press 

the CH p/q buttons on the remote control or the control panel, store 

those channels in the TV’s memory.

 

 

You must set up the antenna/cable input source first. See 

You can set up the TV to detect all active channels in your area and store 

them in its memory. Then you can manually store or skip individual 

channels from memory.

Cable

Note: If you select Cable, auto tuning deletes previously stored channels 

from memory.

This setup requires some time, but you do not need to repeat the setup 

unless your cable TV service’s lineup changes significantly.

Antenna

To skip an antenna source channel and remove it from memory, set the 

.

 

 

To tune to channels not stored in memory, use buttons 0–9 and the DASH 

button on the remote control.

Press the SETUP button.

Select Installation > Channel Tuning > Auto Tuning, and then 

press the OK button.

A confirmation screen appears.

Press the OK button to start Auto Tuning or press EXIT button to 

abort.

The TV cycles through the channels and stores all active channels 

in memory.