Toshiba 32E20U Manual Do Utilizador
Chapter 5: Setting up your TV
25
Programming channels into the
TV’s channel memory
When you press
or
on the remote control
or TV control panel, your TV will stop only on the
channels you programmed into the TV’s channel
memory.
Follow the steps below to program channels into the
TV’s channel memory.
channels you programmed into the TV’s channel
memory.
Follow the steps below to program channels into the
TV’s channel memory.
Programming channels automatically
Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
• You must configure the ANT/CABLE input
source before programming channels
( page 24).
( page 24).
• The automatic channel programming process
will erase channels that were previously
programmed into the TV’s memory.
programmed into the TV’s memory.
• To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
Channel Number buttons on the remote
control.
• Programming channels when the ANT/
CABLE input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however, once channel programming
is finished, you should not have to repeat
the programming process again unless your
Cable TV service lineup changes significantly.
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however, once channel programming
is finished, you should not have to repeat
the programming process again unless your
Cable TV service lineup changes significantly.
To program channels automatically:
1無
Configure the antenna input source, if you have
not already done so ( page 24).
not already done so ( page 24).
2無
Press
and open the
Setup menu.
3無
Highlight
Installation and press
.
4無
(A new set of
Installation menu icons will appear,
as shown below.) Open the
Terrestrial menu,
highlight
Channel Program to bring up the Start
Scan, and press
again to begin channel
programming.
ANT/CABLE Antenna
Scanning channels, please wait ...
Scanning channels, please wait ...
Number of Channels Found - 73
Scanning Digital Channels
Found Channel - 118
Scanning Digital Channels
Found Channel - 118
Abort
52%
The TV will automatically cycle through all the
antenna channels, and store all active channels in the
channel memory. While the TV is cycling through
the channels, the message “Scanning channels,
please wait” appears (as shown above).
antenna channels, and store all active channels in the
channel memory. While the TV is cycling through
the channels, the message “Scanning channels,
please wait” appears (as shown above).
5無
To cancel channel programming, press
on the
remote control (or highlight
Cancel in the on-screen
display and press
).
When channel programming is finished, press
or
to view the programmed channels.
Setting channel skip
To prevent certain channels from being viewed,
channel positions can be skipped.
channel positions can be skipped.
1無
From the
Setup menu, highlight Installation and
press
.
2無
Press p or q to select
Channel Options and press
. The list of channels will appear.
3無
Press p or q to select a channel position to be
skipped and press
skipped and press
. A tick will appear in the
box. To remove the tick, press
again.
(continued)