Toshiba 42AV500U Guia Do Utilizador
Chapter 5: Setting up your TV
0
Programming channels into the
TV’s channel memory
When you press or on the remote control or TV
control panel, your TV will stop only on the channels you
programmed into the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.
control panel, your TV will stop only on the channels you
programmed into the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels in the channel memory.
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels in the channel memory.
Note:
You must configure the antenna input source before
programming channels ( page 29).
The automatic channel programming process erases
The automatic channel programming process erases
channels that were previously programmed into the TV’s
memory.
To tune the TV to a channel not programmed in the channel
To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
Programming channels when the antenna input is
Programming channels when the antenna input is
configured for Cable will take substantially longer than
when the antenna input is configured for Antenna. This is
normal; however, once channel programming is finished,
you should not have to repeat the programming process
again unless your Cable TV service lineup changes
significantly.
To program channels automatically:
Configure the antenna input source, if you have not
already done so ( page 29).
Press
already done so ( page 29).
Press
and open the
Setup menu.
Highlight
Auto Ch Search.
Press u or
to begin channel programming (A new set
of
Auto Ch Search menu icons will appear as shown
below.)
•
•
•
•
1�
2�
3�
4�
The TV will automatically cycle through all the antenna
channels, and store all active channels in the channel
memory. While the TV is cycling through the channels,
the message “Progress(%)” appears a white bar to
indicate the scanning status (as shown above).
channels, and store all active channels in the channel
memory. While the TV is cycling through the channels,
the message “Progress(%)” appears a white bar to
indicate the scanning status (as shown above).
To cancel channel programming, press on the remote
control.
When channel programming is finished, press or to
view the programmed channels.
control.
When channel programming is finished, press or to
view the programmed channels.
Manually adding channels in the channel
memory
Auto Ch Search can search and save channel information
into the channel memory.
There are two ways to add channel information into the
channel memory if the program are not exist in Channel
memory previously:
into the channel memory.
There are two ways to add channel information into the
channel memory if the program are not exist in Channel
memory previously:
(1)To add On Ch Search:
Press
and open the
Setup menu.
Highlight
Add On Ch Search.
Press u or
to begin channel programming (A new set
of Add On Ch Search menu icons will appear as below.)
(2)Manually to add channel on a physical channel
For analog Channel:
Use the Channel Numbers to enter the channel number
that you want to add directly. (digital CH may use the
Dash
that you want to add directly. (digital CH may use the
Dash
on the remote control, for example,56-1 )
Press or on the remote control to save this adding
channel to Channel memory.
channel to Channel memory.
5�
1�
2�
3�
1�
2�