Toshiba 19CV100U Manual Do Utilizador

41)

                                               

Never strike the screen with a sharp or heavy object.

42) • The LCD screen of this product can be damaged 

by ultraviolet radiation from the sun. When 
selecting a location for the television, avoid 
locations where the screen may be exposed to 
direct sunlight, such as in front of a window.

• Never touch, press, or place anything on the LCD 

screen. These actions will damage the LCD screen. 
If you need to clean the LCD screen, follow the 
instructions in item 35 on page 4.

43)

                                                         

Never attempt to service the TV yourself. Opening 
and removing the covers may expose you to 
dangerous voltage or other hazards. Failure to follow 
this WARNING may result in death or serious injury. 
Refer all servicing not specified in this manual to a 
Toshiba Authorized Service Center.

44) If you have the TV serviced:

• Ask the service technician to use only replacement 

parts specified by the manufacturer.

• Upon completion of service, ask the service 

technician to perform routine safety checks to 
determine that the TV is in safe operating 
condition.

45) The fluorescent lamp(s) in the LCD panel contains a 

small amount of mercury.
When the TV reaches the end of its useful life, 
dispose of the used TV by the approved method for 
your area, or ask a qualified service technician to 
properly dispose of the TV.
Note: The lamp(s) inside this product contains 
mercury. Disposal may be regulated due to 
environmental considerations. For disposal or 
recycling information, contact your local authorities or 
the Electronics Industries Alliance (www.eiae.org).

Observe the following safety precautions:

1) Read and Follow the pedestal assembly instructions 

included with the pedestal. 
CAUTION: Before beginning pedestal assembly, 
carefully lay the front of the LCD Panel face down on 
a flat, cushioned surface such as a quilt or blanket. 
Leave the bottom of the TV protruding over the edge 
of the surface and assemble the pedestal as 
indicated below.
Note: Extreme care should always be used when 
attaching the pedestal stand to avoid damage to the 
LCD panel.

2) Place the TV on a sturdy, level surface that can 

support the weight of the TV.

3) Be sure to secure the TV to a wall, pillar, surface, or 

other immovable structure. (

 item 25, page 4).

1) Slide the lever on the back side of the pedestal stand 

to the left.

2) Lay the display down.

IMPORTANT: Do not operate the LCD TV while the 
pedestal stand is folded.

If you decide to wall mount your LCD TV, always use a 
UL listed wall bracket appropriate for the size and weight 
of the LCD TV (

 page 2):

1) CAUTION: Two people are required for installation.
2) Unplug and remove any cables and/or other 

component connectors from the rear of the TV.

3) Follow the instructions provided with your wall 

bracket. Before proceeding, make sure the 
appropriate bracket(s) are attached to the wall and 
the back of the TV as described in the instructions 
provided with the wall bracket.

4) IMPORTANT: Always use the screws supplied or 

recommended by the wall mount manufacturer.

5) After attaching the appropriate bracket(s) to the wall 

and the back of the TV, remove the pedestal stand 
from the TV as described below.