Avaya P333R-LB Manual Do Utilizador
Chapter 3
12
Avaya
P333R-LB User’s Guide
GBIC Expansion Module
The Avaya X330G2 Expansion Module is the GBIC (1.25 Gbit/s Gigabit Ethernet)
Expansion Module for the Avaya P330 family of stackable switches.
Expansion Module for the Avaya P330 family of stackable switches.
Note:
In order to use this module the Avaya P330 switch must must have
Embedded S/W Version 2.2 or higher.
The X330G2 can be used either as a Gigabit Ethernet link or as a high Bandwidth
backplane for connecting switches. The introduction of the GBIC interface to the
Avaya P330 family presents an added value over the existing Gigabit Ethernet
expansion modules. You can insert any of the Avaya-authorized GBIC transceivers
into the X330G2 Expansion Module socket. This provides you with a highly
modular and customisable Gigabit Ethernet interface. The GBIC transceivers are
hot-swappable.
backplane for connecting switches. The introduction of the GBIC interface to the
Avaya P330 family presents an added value over the existing Gigabit Ethernet
expansion modules. You can insert any of the Avaya-authorized GBIC transceivers
into the X330G2 Expansion Module socket. This provides you with a highly
modular and customisable Gigabit Ethernet interface. The GBIC transceivers are
hot-swappable.
Safety Information
The multimode and single-mode GBIC transceivers are Class 1 Laser products.
They comply with EN 60825-1 and Food and Drug Administration (FDA) 21 CFR
1040.10 and 1040.11.
They comply with EN 60825-1 and Food and Drug Administration (FDA) 21 CFR
1040.10 and 1040.11.
The GBIC transceivers must be operated under recommended operating conditions.
Laser Classification
Note:
Class 1 lasers are inherently safe under reasonably foreseeable conditions of
operation.
Caution:
The use of optical instruments with this product will increase eye hazard.
Usage Restriction
When a GBIC transceiver is inserted into the X330G2 Expansion Module but is not
in use, then the Tx and Rx ports should be protected with an optical connector or a
dust plug.
in use, then the Tx and Rx ports should be protected with an optical connector or a
dust plug.
CLASS 1
LASER PRODUCT