Avaya P333R-LB Manual Do Utilizador
Avaya
P333R-LB User’s Guide
49
Chapter 9
Basic Switch Configuration
Introduction
This chapter describes the parameters you can define for the chassis, such as its
name and location, time parameters, and so on.
Use the CLI commands briefly described below for configuring the display on your
terminal or workstation.
name and location, time parameters, and so on.
Use the CLI commands briefly described below for configuring the display on your
terminal or workstation.
In order to...
Use the following command...
Open a CLI session to a P330
module in the stack, ATM or WAN
expansion modules and Media
Gateway Processor of G700.
module in the stack, ATM or WAN
expansion modules and Media
Gateway Processor of G700.
session
Display or set the terminal width
(in characters)
(in characters)
terminal width
Display or set the terminal length
(in lines)
(in lines)
terminal length
Display or set the prompt
hostname
Return the prompt to its default
value
value
no hostname
Clear the current terminal display
clear screen
Set the number of minutes before
an inactive CLI session
automatically logs out
an inactive CLI session
automatically logs out
set logout
Display the number of minutes
before an inactive CLI session
automatically times out
before an inactive CLI session
automatically times out
show logout
Access Layer 3 configuration if not
logged in as supervisor (see “User
Authentication“ chapter)
logged in as supervisor (see “User
Authentication“ chapter)
configure