NEC E462 Guia Do Utilizador

Página de 36
English-31
English-30
Before Calling Service
Please make these simple checks before calling service� These tips may save 
you time and money as charges for receiver installation and adjustments of 
customer controls are not covered under your warranty�
Symptoms
Items To Check And Actions To Follow
“Ghost ” or double 
image when using 
the tuner
•  This may be caused by an obstruction to the 
antenna due to high rise buildings or hills� Using a 
highly directional antenna may improve the picture�
No power
•  Check to see if the display’s AC power cord is 
plugged into the outlet�
•  Unplug the display and after 60 seconds reinsert 
the plug into the outlet and power on the display�
No picture
•  At the rear of the display make sure the antenna 
connection is properly attached�
•  Check to see if there is a station broadcast problem 
by trying multiple channels�
•  Adjust the contrast and brightness settings�
•  Check the Closed Caption settings as some text 
modes may block the visibility of the images on the 
display�
Good picture but no 
sound
•  Increase the VOLUME�
•  Confirm that the display is not muted by pressing 
the MUTE button on the remote control�
Good sound but poor 
color
•  Adjust the contrast, color and brightness settings�
Poor picture
•  Poor picture quality may occur when an activated 
S-VHS camera or camcorder is connected to your 
display and another peripheral at the same time� 
Switch off one of the peripherals�
Snowy picture and 
noise when using the 
tuner
•  Check the antenna connection and signal�
Presence of a 
horizontal dotted line
•  This may be caused by electrical interference (e�g� 
hairdryer, nearby neon lights, etc�)�
•  Power cycle the equipment by turning off and then 
turning back on�
Display not 
responding via the 
remote control
•  Determine if the batteries are working and replace 
batteries if necessary�
•  Clean the remote control sensor lens on the 
display�
•  If necessary, utilize the buttons located on the side 
of the display�
•  Select the TV mode to ensure your remote control 
is set in the TV mode�