Honeywell HRDE4X4 Manual Do Utilizador

Rev 2.00

16

Document 900.0399

03/06

When you select Partial Zone in the Motion Zone menu, you can set up motion sensing 
zones (see 

). 

To move around each rectangular zone, use the arrow controls. Press SEL on each 
rectangular zone you want to include as part of the motion sensing zone. As you select each 
zone, the color changes. Press ESC to return to the Record Menu.

Assign the recording mode for each channel. Options are:
CONTINUOUS
BY MOTION
BY SENSOR (record based on sensor inputs)
BY SCHEDULE
DISABLE

Select motion sensing zones. Options are:
FULL ZONE
PARTIAL ZONE

If Partial Zone is selected (press SEL), the screen will change as 

shown in 

.

Set the motion sensitivity for the specified channel, from:
1 to 9

Set the type of sensor for the specified channel (see 

 for connection information). Options are:

None
N/O normal open (ground connected to the input starts recording)
N/C normal closed (ground connected to the input stops recording)

Enable/disable pre-event recording. Pre-event recording time is five 
seconds and only intra-frames are recorded for pre-event recording.

Set post event recording time duration for the specified channel 
(choose from 2–30 seconds).

Enable/disable alarm output for the specified channel. The alarm output 
relay can be closed by either a motion event or a sensor input, if 
enabled.

Set the alarm time duration for the specified channel (choose from 1–60 
seconds).

Enable/disable audio recording for the specified channel. Audio must 
be set to ON to hear live audio. On the local unit, audio can be heard 
live and in playback. Only audio for the selected camera will be heard. 
On the remote access software audio can only be heard in live mode.

Set the recording schedule. This menu item takes you to the Schedule 
Setup screen (see 

).