Pelco DX3116 Manual Do Utilizador
C695M-B (11/03)
29
SYSTEM STATUS AND UPGRADE
Highlight the SYSTEM STATUS & UPGRADE option on the setup menu screen and press the ENTER button. The SYSTEM STATUS &
UPGRADE screen is shown in Figure 16. It provides access to important system details.
UPGRADE screen is shown in Figure 16. It provides access to important system details.
Figure 16. System Status Screen
SIGNAL SYSTEM
Displays the setting of the NTSC/PAL switch on the rear of the unit.
HDD SPACE USED
Displays the used storage space and the total available storage space.
SOFTWARE
VERSION
VERSION
Displays the version of the currently installed software.
HARDWARE
VERSION
VERSION
Displays the current hardware version.
IP ADDRESS
Displays the IP address for the unit that was entered on the NETWORK SETUP screen.
MAC ADDRESS
Displays the unique MAC (Media Access Control) address for the network interface card for the DX3100. The MAC
address consists of six bytes of hexadecimal values.
address consists of six bytes of hexadecimal values.
SOFTWARE
UPGRADE
UPGRADE
Use this option to upgrade the DX3100 system software, either from a set of floppy diskettes or from a network
drive. Refer to the
drive. Refer to the
Software Upgrade section in the DX3100 Series Remote Site Software manual for complete
information.
SYSTEM STATUS & UPGRADE
SOFTWARE VERSION
HARDWARE VERSION
IP ADDRESS
SIGNAL SYSTEM
MAC ADDRESS
V1.1.0
NTSC
10.0 / 60.0 GB
V1.1
00:06:38:00:00:02
192.168.000.002
SOFTWARE UPGRADE
:
:
:
:
:
:
:
HDD SPACE USED
FDD
LAN