Q-See QSD2308L Manual Do Utilizador

QSD2308L/QSD2316L DVR User’s Manual

3.3 Recording

3.3.1 Record Setup

Users need to install and format a HDD, and set all the recording

parameters before recording.

Note

: Some vendors sell the DVR with a hard drive already installed, if this is the case

you just need to set the recording parameters.

There are four recording modes. Users can enable them simultaneously,

but only one recording mode works at a time. They have different priorities,
the priority order is below:

Motion detection recording > Sensor recording > Manual recording > Timer
recording

Press right mouse button to show the control bar, refer to Fig 4.1 Control

Bar. Enter Menu---->System.

STEP1

Enter RECORD configuration, refer to

Fig 3.7 Record Setup, Select cameras.

Fig 3.7 Record Setup

STEP2

Set Video quality, Frame rate and Resolution.

STEP3

Have Audio checked if you input audio and want to record. Check

Time stamp to record
STEP4

Enable recording function for cameras in Record option.

Note

: If you have a camera uncheck here, it will not record in any recording mode.

STEP5

Set Alarm record hold time. It is for post alarm recording.

STEP6

Enable Recycle. It replaces old video with new files after HDD is

full. If you have it unchecked, it will stop recording automatically once HDD is
full
STEP7

Click OK to finish

Note

: The higher the Video quality, Frame rate and Resolution, the more storage space

is used every hour.

This Unit supports pre-alarm recording. But there is no option to set the

pre-alarm recording time, the default is 10 seconds