Sanyo DSR-M800 Manual Do Utilizador

4

Follow the steps below to have the digital video recorder 
record an alarm image only when alarm input is detected 
during recording.

z

Check that the cable of the device required for alarms is 
connected to the ALARM terminal. (JP.8)

The default settings are shown below. See P.27 for how to 
change these settings. 
z

ALARM MODE: “ENABLED”
Alarm recording is always performed, whether or not 
timer recording is set.

z

ALARM DURATION: “20SEC”
Recording is performed for 20 seconds for each alarm 
signal received.

z

When an alarm is received, “AL” flashes in the 
operation display area, the ALARM indicator flashes, 
and the alarm image is recorded.

z

Each time an alarm is received, the alarm count in the 
operation display area is incremented by 1.

When the alarm duration time (default setting: 20 seconds) 
ends, “AL” disappears from the operating display, the 
ALARM indicator stops flashing, and recording ends.

z

When the hard disk’s remaining space for recording 
reaches zero, the FULL indicator lights and recording 
ends. You can start recording from the beginning again 
by changing the recording setting. (JP.27)

ALARM indicator

Counts number of 
alarms.

e_dsr_m800.book  Page 15  Friday, January 31, 2003  5:45 PM