Woodstock m1043 Manual Do Utilizador
-10-
M1043 48" Pan and Box Brake
SE
TU
P
Some components for
this equipment are
heavy and awkward
to handle. Assembling
them without prop-
er equipment may
increase the likeli-
hood of injury.
The Model M1043 must be mounted to a bench before it
can be safely operated.
To mount the Model M1043 to a bench, do these
steps:
1. Place the brake on the workbench.
2. Use the holes in the base as a guide for drilling and
attaching the pan and box brake to the workbench
(see
Figure 6).
We recommend using through bolts (hex bolts that
go all the way through the workbench and are
secured from the other side with flat washers and
hex nuts) if possible.
If it is not possible to use through bolts because of
your workbench construction, use lag screws with
flat washers and fasten the lag screws directly into
the workbench.
Mounting to Bench
Figure 6. Mounting holes.
The counterweight provides additional leverage to assist
the operator when bending heavy gauge material.
To mount the counterweight, slide the counterweight
shaft 3" or 4" into the sleeve on the left-hand side of the
brake, and tighten the cap screws as shown in
Figure 7.
Mounting Counterweight
Figure 7. Mounting the counterweight.