Woodstock m1043 Manual Do Utilizador
-13-
M1043 48" Pan and Box Brake
O
PE
R
AT
IO
N
S
2. Loosen the cap screws on the setback wheels.
3. Rotate both setback wheels evenly (Figure 10) to
move the front edge of the fingers toward or away
from the edge of the clamp block.
Note: Make sure the finger edges are parallel with
the edge of the clamp block or your bend will be
distorted.
Spacing Fingers
The fingers can be spaced apart for clearance when mak-
ing pans or boxes. This requires removing one or more of
the fingers so that you can space the others to match the
width of your pan or box (
Figure 11).
To space the fingers apart, do these steps:
1. Remove one of the end fingers by loosening the cap
screw, shown in
Figure 12, and slide it off the front
guide.
2. Loosen the top cap screws of the fingers you need to
move, and slide them across the front guide so that
you have adequate room for your workpiece on both
sides.
Note: You may need to mix and match finger widths
to equal the size of your workpiece.
3. Align the fingers and tighten the cap screws. (See
Page 11 for alignment instructions.)
Figure 11. Fingers spaced apart to allow
clearance of pan or box sides.
Figure 12. Top cap screw for loosening
finger in order to slide it off the front
guide.
Cap Screw
Figure 10. Cap screw and setback wheel.
Setback wheel
Cap Screw