DISH Network Solo 811 Manual Do Utilizador

If the code for your device is not listed in the device codes on page 86, use 
this procedure to scan the remote control’s memory for the device code. In 
the following instructions, the column on the left contains the instructions 
and the column on the right provides additional information. 

11

If you can’t find a code that 
works try, Setting Up Using 
Device Codes Scan that fol-
lows.

1. Turn the device on.

Use the device’s front panel buttons 
or its remote control.

2. Press and hold the mode 

button until all the other mode 

buttons light up, and then let 

go of the button.

The mode button flashes.

 

 

For example, hold the TV mode 
button for a TV until all of the other 
mode buttons light. When you let go, 
the TV mode light will flash.

3. For AUX mode only. Press 0 

for a second TV, or 1 for a 

VCR or DVD player, or 2 for 

a tuner, or amplifier. Press the 

STAR (*) button.

This step is for programming which 
kind of device that should be 
programmed in AUX mode. If you’re 
not programming in AUX mode, skip 
to step 4. 

4. Press the POWER button.

This puts your remote in the scan 
mode.

5. Press the either the UP or 

DOWN ARROW button 

repeatedly until the device 

turns off.

As you press the UP or DOWN 
ARROW button, the remote is trying 
each code in the memory to see if it 
can turn off your device. When the 
device turns off, you have found a 
code that might work.

 

The mode button for the device 

will flash rapidly eight times when 
you’ve scanned all the codes for that 
device.

6. Press the POUND (#) button.

This stores the code you found.