Avaya 4602 Manual Do Utilizador

CAUTION:

Perform these procedures only if instructed to do so by the system or LAN 
administrator.

Static administration of these options causes upgrades to work differently than if 
they are administered dynamically. Values assigned to options in static 
administration are not changed by upgrade scripts. These values remain active 
for the telephone until either:

Aside from SSON, use these option-setting procedures only with static addressing 
and, as always, only if instructed by the system or LAN administrator. Aside from 
SSON, do not use these option-setting procedures if you are using DHCP. DHCP is 
the Dynamic Addressing Process, as indicated in 

page 27.

This section applies to all IP telephones with a display. It does not apply to the 4601 IP 
Telephone, which does not have a display. This section describes how to enter data for 
administrative options.

1. Invoke all local procedures by pressing the Hold or Mute button, up to 7 numeric dial pad 

buttons, and the # button. The 4630/4630SW IP Telephones and the 4690 IP Conference 
Telephone do not have a dedicated Hold button. On these phones, you must use the Mute 
button to access these options. 

A 6-second timeout is in effect between button presses after pressing the Hold button. If 
you do not press a valid button within 6 seconds of pressing the previous button, the 
collected digits are discarded. In this case, no administrative option is invoked.

2. Attempts to enter invalid data are rejected, and the phone emits an error beep.

3. If you enter a numeric digit for a value or for an IP address or subnet mask field after 

entering only a zero, the new digit replaces the zero.

4. Press the # button to go to the next step.

●

a new boot file is downloaded, or 

●

the IP telephone is reset, as indicated in