Avaya 40DHB0002USCL Manual Do Utilizador

 

 

Audio I/P Socket

 

 

EXPANSION 

    1          2          3         4          5         6

 

DTE

 

WAN

 

 

 

DC Power I/P Socket

 

External O/P Socket

 

DTE Port

 

WAN Port

 

Expansion Ports 1-6

 

 

•  External O/P Socket 

Two relay ports that allow externally powered circuits to be controlled via a single 3.5mm stereo 

jack socket. 

•  DC Power I/P Socket 

Socket for the external 24V DC unregulated power supply (supplied with kit). 

•  DTE Port 

A 25-way D-type socket. Used for connection to PCs, servers and EFTPOS terminals. 

The trunk interface modules are fitted into either Slots A or B and can consist of any combination 

of: 

 

  

PRI E1/PRI E1-R2: 30 trunks  

 

 

Quad BRI: 8 trunks. 

PRI T1 trunks support both ISDN and Analog emulation. The default setting is 23B+1D and is 

switchable in the installation software to provide 24B trunks. 

•  WAN Port 

This port supports a single synchronous data connection, which can be X.21, V.35 or V.24. The 

selection of the required interface is automatically determined from the pin-out of the cable 

plugged into the ‘WAN’ port. This cable must be connected before power is applied for auto 

detection to work. Connection to a Digital Leased Circuit is made by connecting the WAN port on 

the rear of the unit to the existing Network Terminating Unit (NTU) via the appropriate X.21, V.35 

or V.24 cable.  
See pages 62, 63 and 64 for cable details and page 54 for port details. These interfaces are 
identical to those on the WAN3 Extension Module (see page 30). 

•  Expansion Ports 1-6 

Used to provide access to the optional Expansion Modules (see page 27) which allow the IP406 

•  Audio I/P Socket 

A single 3.5mm stereo or mono jack socket that enables input from an external 'Music-on-Hold' 

source. 

Port Pinouts and Cables 
For Port Pinouts and Cables, refer to pages 51 and 55 respectively.