Panasonic KX-A272 Manual Do Utilizador
14 | Operating Instructions
Serial Repeater ID programming continued.
•
Ensure that the repeater is switched OFF. (both LED’s are OFF)
•
Power ON the repeater.
•
Assign the repeater to a base by following either the manual or automatic
registration process.
registration process.
•
Bring the repeater into close range of the repeater on the parent level (i.e. when
assigning a repeater to chain-level 3, the repeater must be brought into close range
with the repeater already set to chain-level 2.).
assigning a repeater to chain-level 3, the repeater must be brought into close range
with the repeater already set to chain-level 2.).
•
Press the switch the corresponding number
of times to set the chain-level.
(i.e. 3 times = chain-level 3 etc.).
The red LED flashes a number of times
corresponding to the chain level.
of times to set the chain-level.
(i.e. 3 times = chain-level 3 etc.).
The red LED flashes a number of times
corresponding to the chain level.
NB: Pressing the switch 4 or more times
corresponds to chain-level 1.
corresponds to chain-level 1.
•
After two minutes from power ON, the new chain-level and Radio Fixed Part Identity
(R.F.P.I.) are then stored into the repeaters memory, and the repeater returns to
normal operation.
(R.F.P.I.) are then stored into the repeaters memory, and the repeater returns to
normal operation.
•
Please note : This function is not available for domestic DECT appliances, only
PBX.
QUQX00130YA_01_A 20/1/04 6:41 pm Page 14