Nortel Networks M7410 Manual Do Utilizador
Using System features 101
P0908510 Issue 02
Enterprise Edge Feature Programming Telephone Guide
Using an auxiliary ringer
An auxiliary ringer is a separate device that has to be connected to Enterprise Edge.
Turning the auxiliary ringer for a telephone on or off
You need to start a Unified Manager session to program this feature. For more
information about programming using the Unified Manager, see the Enterprise
Edge Programming Operations Guide.
information about programming using the Unified Manager, see the Enterprise
Edge Programming Operations Guide.
Your installer can program the auxiliary ringer to start ringing for incoming lines as
part of Ringing Service.
part of Ringing Service.
Using Host System dialing signals
You can access host systems, such as private branch exchanges (PBX) from
Enterprise Edge by using host system signaling features (known as end-to-end
signaling). These features either send a special signal to the host system or allow
you to program delays required by host systems in external autodial or speed dial
sequences.
Enterprise Edge by using host system signaling features (known as end-to-end
signaling). These features either send a special signal to the host system or allow
you to program delays required by host systems in external autodial or speed dial
sequences.
Link
ƒ‡⁄
If your Enterprise Edge system is connected to a private branch exchange (PBX),
you can use a Link signal to access special features. On some telephones, Link is
called FLASH.
you can use a Link signal to access special features. On some telephones, Link is
called FLASH.
The Link signal can be included as part of a longer stored sequence on an external
autodial button or in a speed dial code. The Link symbol (
autodial button or in a speed dial code. The Link symbol (
¤
) uses two of the 24
spaces in a dialing sequence.
Preventing a telephone from using Link
Link can be restricted at individual telephones. You need to start a Unified Manager
session to program this feature. For more information about programming using the
Unified Manager, see the Enterprise Edge Programming Operations Guide.
session to program this feature. For more information about programming using the
Unified Manager, see the Enterprise Edge Programming Operations Guide.
Tip
If your Enterprise Edge system is connected to a private branch exchange
(PBX), program Link onto a memory button for one-touch access.
If your Enterprise Edge system is connected to a private branch exchange
(PBX), program Link onto a memory button for one-touch access.