Samsung DCS KEYSET Manual Do Utilizador

– 29 – 

 is used for pulse-to-tone conversion (“C”). If your system uses ro-

tary (or pulse) dialling C.O. lines, pressing D while entering a speed 
dial number causes all subsequent digits to be sent as DTMF tones. 

 is used to hide digits. You may want to hide some phone numbers 

so that they will not show in the display when you dial the speed dial 
number later. When you are programming the phone number, press E 
before entering the digits you want to hide. The symbol “[” is dis-
played. All subsequent digits will be displayed as “*” when the speed 
dial number is dialled. If you want some digits to display, press E 
again (“]” is displayed) before entering these digits.  

 

For example, if you program a speed dial number with the phone 
number 9-[0121]728765, when you later dial this speed dial number 
the display shows ****728765. 

 
Note: When programming an outside number, enter the access code (e.g. 9 or 0) 
before you press E to hide any digits. 
 

 is used to enter a name for the speed dial number. See Personal 

Speed Dial Names under Display Features.       
                                                                                                               
Use the 

 key to clear a speed dial number and/or name. 

 

You can assign any personal or system speed dial number to an al-
ready programmed speed dial key for quick and easy one-touch dial-
ling of frequently-used numbers. 

 

1.  While on-hook, press the 

 key and dial 107. 

2. Press an 

SPD 

key.                   

3.  Dial the speed dial number that you want assigned to this key. 
4. Press the 

 key to store your selection. 

 

To call this number, simply press the 

SPD 

key.