Avaya MDW 9040 Manual Do Utilizador
2
Installing the MDW 9040 Pocket Phone System
Installation Procedures for Dual Radio
MDW 9040 Wireless Pocket Phone Installation and Use,
503-801-190
14
Issue 2, February 2001
Installation Procedures for Dual Radio Modules
There are three types of installations according to the needs of your wireless communications system.
1
Installing one radio module for single zone operation, the simplest type of
configuration; for information on this type of configuration, use the procedures on
configuration; for information on this type of configuration, use the procedures on
.
2
Installing multiple radio modules for single zone operation; for information on
this type of configuration, use the procedures on
this type of configuration, use the procedures on
3
Installing multiple radio modules for dual zone operation; for information on
this type of configuration, use the procedures on
this type of configuration, use the procedures on
Before you begin installation, please review the “
and information about positioning the radio module on
.
Note:
For some installers, it may be more convenient to unpack the radio
module and handset in the switch room, power up the radio module, and
then register the handset prior to installing the radio module. For this
procedure, refer to the introductory information and figures for the radio
module in this section and then follow the registration procedures
outlined in
module and handset in the switch room, power up the radio module, and
then register the handset prior to installing the radio module. For this
procedure, refer to the introductory information and figures for the radio
module in this section and then follow the registration procedures
outlined in
Before you register the handset with the radio module, you must insert
the charged battery pack in the handset. See “
the charged battery pack in the handset. See “
” later in this Chapter.
A radio module can be placed on a flat surface such as a desk or shelf OR mounted on
the wall.
the wall.
Wall-Mounting the Dual Radio Module
To wall-mount a radio module:
1
Remove the radio module and mounting plate from its shipping box. Choose a
location where one of the screw holes will be backed by a wooden stud (if
unavailable, use toggle bolts instead of the supplied wood screws). Hold the plate
straight; use a level if needed.
location where one of the screw holes will be backed by a wooden stud (if
unavailable, use toggle bolts instead of the supplied wood screws). Hold the plate
straight; use a level if needed.
2
Using the plate, mark the locations for the two wall-mounting screws. Lightly tap
a nail into the wall to start the holes.
a nail into the wall to start the holes.