Toshiba 50HM67 Manual Do Utilizador
10
HM67 (E/F) Web 213:276
Chapter 1: Introduction
Overview of steps for installing,
setting up, and using your new TV
setting up, and using your new TV
Follow these steps to set up your TV and begin using its many
exciting features.
exciting features.
1
Carefully read the important safety, installation, care, and
service information. Keep this manual for future
reference.
service information. Keep this manual for future
reference.
2
Observe the following when choosing a location for the
TV:
TV:
•
Read “Important notes about your DLP
®
projection
TV” (- page 6).
•
Place the TV on the applicable optional TV stand listed
in the “Specifications” section (if available for this TV
model) or on a sturdy, level, stable surface that can
safely support the size and weight of the unit.
in the “Specifications” section (if available for this TV
model) or on a sturdy, level, stable surface that can
safely support the size and weight of the unit.
•
Place the TV in a location where light does not reflect
on the screen.
on the screen.
•
Place the TV far enough from walls and other objects to
allow proper ventilation. Inadequate ventilation may
cause overheating, which will damage the TV. THIS
TYPE OF DAMAGE IS NOT COVERED UNDER
THE TOSHIBA WARRANTY.
allow proper ventilation. Inadequate ventilation may
cause overheating, which will damage the TV. THIS
TYPE OF DAMAGE IS NOT COVERED UNDER
THE TOSHIBA WARRANTY.
3
Do not plug in any power cords until AFTER you have
connected all cables and devices to your TV.
connected all cables and devices to your TV.
4
BEFORE connecting cables or devices to the TV, learn
the functions of the TV’s connections and controls
(
the functions of the TV’s connections and controls
(
-
pages 11–12).
5
Connect your other electronic device(s) to the TV
(
(
-
pages 13–21).
6
Install the batteries in the remote control (
-
page 22).
7
See “Learning about the remote control” (
-
page 23) for
an overview of the buttons on the remote control.
8
Program the remote control to operate your other
device(s) (
device(s) (
-
pages 24–28).
9
AFTER connecting all cables and devices, plug in the
power cords for your TV and other devices.
power cords for your TV and other devices.
10
After you plug in the TV power cord, the yellow LED
(on the TV front) will blink 3 times. Wait several seconds
until the yellow LED stops blinking and then press p on
the TV or remote control.
See “LED indications” (- page 62).
(on the TV front) will blink 3 times. Wait several seconds
until the yellow LED stops blinking and then press p on
the TV or remote control.
See “LED indications” (- page 62).
11
See “Menu layout and navigation” for a quick overview of
navigating the TV’s menu system (
navigating the TV’s menu system (
-
page 29).
12
Program channels into the TV’s channel memory
(
(
-
page 32).
13
For details on using the TV’s features, see Chapters 6
and 7.
and 7.
14
For help, refer to the Troubleshooting Guide, Chapter 8.
15
For lamp unit replacement instructions, see
Chapter 9.
16
For technical specifications and warranty information, see
Chapter 9.
Chapter 9.
17
Enjoy your new TV!
50HM67_EN.book Page 10 Thursday, March 29, 2007 11:28 AM