Viewsonic PJD5152 Guia Do Utilizador
Operation
35
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
•
Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings menu sets
the length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use
the length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use
/
to select a suitable time
frame.
•
Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the
OSD position in five locations. Use
OSD position in five locations. Use
/
to select a preferred position.
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for the
OSD menus. Use
OSD menus. Use
/
to select your language.
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use
displayed during projector start-up. Use
/
to select a screen.
Shutting down the projector
1.
Press
POWER and a confirmation message
is displayed prompting you.
If you don't respond in a few seconds, the
message will disappear.
If you don't respond in a few seconds, the
message will disappear.
2.
Press
POWER a second time. The
POWER indicator light flashes blue, the
projection lamp shuts down, and the fans will
continue to run for approximately 90 seconds
to cool down the projector.
projection lamp shuts down, and the fans will
continue to run for approximately 90 seconds
to cool down the projector.
3.
Disconnect the power cord from the wall
socket if the projector will not be used in an
extended period of time.
socket if the projector will not be used in an
extended period of time.
CAUTION
•
•
To protect the lamp, the projector will not respond
to any commands during the cooling process.
to any commands during the cooling process.
•
To shorten the cooling time, you can also activate
the Quick Cooling function. See
the Quick Cooling function. See
for details.
•
Do not unplug the power cord before the projector shutdown sequence is complete or
during the 90-second cooling down process.
during the 90-second cooling down process.
•
If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press POWER again to
start the projector after the fans stop and the POWER indicator light flashes blue.
the projector, the fans will run for a few minutes to cool down. Press POWER again to
start the projector after the fans stop and the POWER indicator light flashes blue.
I
I
I
I
I
I