Panasonic PT-LB51E Manual Do Utilizador

Depending on the projection environment, you can use 
these preset parameter settings to optimise image 
projection. Press I H to cycle through the options.

You can adjust the contrast of the projected image. 
Adjust the BRIGHTNESS in advance if necessary.

You can adjust the brightness of the projected image.

(S-VIDEO/VIDEO/COMPONENT signals only)
You can adjust the colour saturation of the projected 
image.

(NTSC/NTSC 4.43/COMPONENT signals only)
You can adjust the skin tone in the projected image.

You can adjust the sharpness of the projected image.

You can adjust the white balance of the projected image.

  LOW

More bluish

  STANDARD

Balanced white

  HIGH

More reddish

Setting for a general image

Bright and sharp setting

Setting for when projecting on 
a blackboard
See “BLACKBOARD” on 
page 38.

Reproduces the original colour 
of the image

• It may take for a while until the selected mode is 

stabilised.

• When FUNCTION BUTTON is set to "PICTURE 

MODE" (see “FUNCTION BUTTON” on page 36), the 
PICTURE MODE operation can also be carried out by 
pressing the FUNCTION button at the front of the 
projector.

 

 

sRGB is an international colour reproduction standard 
(IEC61966-2-1) established by the International 
Electrotechnical Commission (IEC).
If you would like the colours in sRGB-compatible 
pictures to be reproduced more faithfully, make the 
following settings.

1. Press the F or G button to select “PICTURE 

”, and then press the I or H button to 

select “NATURAL”.

2. Press the DEFAULT button on the remote control 

unit.

3. Press the F or G button to select “COLOR 

”, and then press the I or H 

button to select “STANDARD”.

• sRGB is only enabled when RGB signals are being 

input (when “LAMP POWER” is set to “STANDARD”, 
“AI” is set to “OFF”, and “DAYLIGHT VIEW” is set to 
“OFF”).