Samsung HC-P5252W Manual Do Utilizador
13
I
N S TA L L AT I O N
1
Find and disconnect the cable
that is connected to the
ANTENNA IN terminal on your
cable box.
that is connected to the
ANTENNA IN terminal on your
cable box.
Connecting to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such as premium channels), follow the
instructions below. You will need a two-way splitter, an RF (A/B) switch, and four lengths of
coaxial cable. (These items are available at most electronics stores.)
instructions below. You will need a two-way splitter, an RF (A/B) switch, and four lengths of
coaxial cable. (These items are available at most electronics stores.)
2
Connect this cable to a two-
way splitter. Connect a coaxial
cable between an OUTPUT
terminal on the splitter and the
IN terminal on the cable box.
way splitter. Connect a coaxial
cable between an OUTPUT
terminal on the splitter and the
IN terminal on the cable box.
œ This terminal might be labeled
“ANT IN”, “VHF IN”, or
simply “IN”.
simply “IN”.
3
Connect a coaxial cable
between the ANTENNA OUT
terminal on the cable box and
the B-IN terminal on the A/B
switch.
between the ANTENNA OUT
terminal on the cable box and
the B-IN terminal on the A/B
switch.
4
Connect another cable
between the other OUT
terminal on the splitter and the
A-IN terminal on the RF (A/B)
switch.
between the other OUT
terminal on the splitter and the
A-IN terminal on the RF (A/B)
switch.
5
Connect the last coaxial cable
between the OUT terminal on
the RF (A/B) switch and the
“ANT 1 IN” terminal on the
rear panel.
between the OUT terminal on
the RF (A/B) switch and the
“ANT 1 IN” terminal on the
rear panel.
After you’ve made this connection, set the A/B switch to the “A” position for normal viewing. Set the A/B
switch to the “B” position to view scrambled channels. (When you set the A/B switch to “B,” you will
need to tune your TV to the cable box’s output channel, which is usually channel 3 or 4.)
switch to the “B” position to view scrambled channels. (When you set the A/B switch to “B,” you will
need to tune your TV to the cable box’s output channel, which is usually channel 3 or 4.)
Incoming Cable
Splitter
Cable Box
RF (A/B)
Switch
BP68-00289A-02Eng 7/21/04 10:01 AM Page 13