Runco VX-2ix Manual Do Utilizador
Runco VX-2ix Owner’s Operating Manual
49
5.3
Troubleshooting Tips
Troubleshooting Tips
Table 5-1 provides some general guidelines for troubleshooting problems you may
encounter with the VX-2ix. If you encounter an issue not described here, please contact
Runco Technical Support.
encounter with the VX-2ix. If you encounter an issue not described here, please contact
Runco Technical Support.
Table 5-1. Troubleshooting Chart
Symptom
Possible Cause(s)
Solution
The projector does not turn
on after initial installation. The
power LED lights red after you
press the power button.
on after initial installation. The
power LED lights red after you
press the power button.
• The VX-2ix is not plugged
in or the AC outlet is not
active.
active.
• Ensure that the VX-2ix is
plugged in and that the AC
outlet is active.
outlet is active.
The projector is on, but there
is no video image on-screen.
is no video image on-screen.
• Incorrect source selection.
• Source component is not
• Source component is not
turned on.
• Select the correct source.
• Turn on the source.
• Turn on the source.
A projected image from a
DVD is split or otherwise
scrambled.
DVD is split or otherwise
scrambled.
• DVD player is set to
progressive scan mode.
• Turn off progressive scan
on the DVD player.
• Connect the DVD player to
the HD/RGB 1 or
HD/RGB 2 input.
HD/RGB 2 input.
Image is too bright and/or
lacks definition in the bright
areas of the image.
lacks definition in the bright
areas of the image.
• Contrast is set too high.
• Lower the contrast setting.
Image appears “washed out”
and/or dark areas appear too
bright.
and/or dark areas appear too
bright.
• Brightness is set too high.
• Lower the brightness
setting.
Colors in the image are
swapped; for example, reds
appear blue or vice versa.
swapped; for example, reds
appear blue or vice versa.
• The Red/Pr, Green/Y or
Blue/Pb outputs from the
source are connected to
the wrong inputs on the
VX-2ix.
source are connected to
the wrong inputs on the
VX-2ix.
• Ensure that the source
outputs are connected to
the correct VX-2ix input.
the correct VX-2ix input.
Image geometry is incorrect.
• Incorrect aspect ratio
selection.
• Select the aspect ratio that
The projector will not turn
back on after it was powered
down, or the image disap-
pears during operation.
back on after it was powered
down, or the image disap-
pears during operation.
• The projector will not turn
on for two minutes after
power-down, to protect
the lamp.
power-down, to protect
the lamp.
• The lamp has failed.
• Wait two minutes until the
LED at the front of the
VX-2ix turns red.
VX-2ix turns red.