Mitsubishi Electronics AJ65bt-r2 Manual Do Utilizador
5 - 9
MELSEC-A
5 PRELIMINARY INFORMATION
5.4 Initializing the master station
Create the following program to initialize (set the parameters, start the data link) the
master station.
Refer to section 5.1 for details on the program conditions.
master station.
Refer to section 5.1 for details on the program conditions.
(Example) No. of connected modules: One module, Connected station: R2 (Station
No. 1, one station occupied)
(1) Set the No. of
connected modules
connected modules
(2) Set the station
information
information
(3) Set the master
station buffer memory
station buffer memory
Refresh indication
Start data link with buffer
memory
memory
If normal, reset start
request signal
request signal
If error, read parameter state
Reset start request signal
POINT
When setting the information (1) to (3) as parameters when using QCPU (Q mode)
or QnACPU, the above program is not required.
or QnACPU, the above program is not required.
(1) No. of connected modules (
M
1
H
)
Set the No. of remote I/O stations, remote device stations, intelligent device
stations and local stations connected to the master station. (Including the
reserved stations.)
stations and local stations connected to the master station. (Including the
reserved stations.)