JVC AV 56P777 Manual Do Utilizador

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes pre-
set with a lock code of “0000”. You may change the code to any four-digit number you wish. To 
change the lock code, follow the steps below.

 

Press the M

ENU

 button

π†

 

To "Initial Setup"

è

 To 

enter

π† 

To "Set Lock Code"

√®  

To operate (Password input screen will appear)

 

 Enter the password by using the 10 button 
keypad

 

 

 To set the password, use the 10 button keypad

 

Press the O

K

 button to finish (your lock code is now set)

•  After a power interruption you must reset the lock code.

•  Write your lock code number down and keep it hidden from potential viewers.

•  If you forget the lock code, a new code may be set using the steps listed above.

When a viewer attempts to watch a blocked channel, 
this message appears:

The channel will remain blocked until the correct lock 
code is entered (see above for information on setting 
your lock code).

This programming exceeds

your rating limits.

Please enter lock code 

by 10 key pad to unlock it.

No. - - - - 

When a viewer attempts to watch a guarded channel, the following message appears:

To watch a channel that you have locked, enter the 
Lock Code using the 10 key pad. 
If the wrong code is entered, the message "invalid lock 
code !” will flash on the screen.

The channel cannot be accessed until the correct code 
is entered.

•   Once a channel has been unlocked, it will remain unlocked until the television is turned off.

 

•   See also “Set Lock Code”, page 38. 

This channel is locked 

by channel guard.

Please enter lock code 

by 10 key pad to unlock it.

 No. - - - -  

Exit

MENU

Select

Operate

Initial Setup > Set Lock Code

Back

BACK

OK

Clear

Lock Code

Set

0   1   2   3

LCT2121-001A-A English.indd   38

LCT2121-001A-A English.indd   38

6/21/06   9:30:36 AM

6/21/06   9:30:36 AM