Invacare Top End XLT Jr. Manual Do Utilizador

SECTION 6—RIDING POSITION

Adjusting Back Angle - All Models Except XLT Gold and
Top End Force

NOTE: For this procedure, refer to FIGURE 6.9.

1. If installed activate parking brake.

2. Loosen, but DO NOT remove the four rear socket screws that secure the seat frame to

the handcycle frame.

NOTE: There are two socket screws on the right and left side of the handcycle.

3. Loosen, but DO NOT remove the hex bolts and locknuts that secure the two seat angle

adjustment clamps to the rear seat supports.

NOTE: There is one clamp on the right and left side of the handcycle.

4. Perform one of the following:

• Increasing Back Angle ‐ While lifting up on the back support tubes, pull the seat

upward to the desired position.

• Decreasing Back Angle ‐ While pushing down on the back support tubes, push the

seat down to the desired position.

5. Tighten the four socket screws that secure the seat frame to the handcycle frame

securely.

6. Tighten the hex bolts and locknuts that secure the two seat angle adjustment clamps

to the rear seat supports securely.

FIGURE 6.9 Adjusting Back Angle - All Models Except XLT Gold and Top End Force

Seat Angle Adjustment Clamps

Back Support Tube

Rear Socket Screws

Handcycle Frame