Invacare 6372 Manual Do Utilizador
3
Leg Extensions and
Wheeled Walker Accessories
Installing Fixed Wheel Attachments/Leg Extensions
NOTE: For this procedure, refer to FIGURE 1.
NOTE: Refer to Installation Warning on page 2.
NOTE: Refer to Installation Warning on page 2.
1. Press the snap buttons on the walker frame to remove the two existing front leg extensions
from the walker.
NOTE: The front leg extensions will not be reassembled to the walker when using the wheel
attachments/leg extensions.
NOTE: For 3 and 5 inch fixed wheels (model nos. 6270, 6271, and 6278), position the wheels on the
outside of walker.
attachments/leg extensions.
NOTE: For 3 and 5 inch fixed wheels (model nos. 6270, 6271, and 6278), position the wheels on the
outside of walker.
2. Press the snap button on the walker frame and install the new wheel attachment/leg
extension onto front leg of the walker.
3. Repeat STEP 2 for remaining front leg.
4. Adjust the wheel attachment/leg extension to one of the adjustment holes.
5. Perform one of the following:
• Install the rear leg extension options, if necessary. Refer to Installing Rear Leg
• Remove rear rubber tips and replace with glide tips included. Refer to Installing the
NOTE: When using 10 inch rear leg extensions, the adjustment ranges are reduced on Model Nos. 6273
and 6267.
and 6267.
6. Ensure that the snap button of each leg fully protrudes through the desired adjustment
hole and legs are adjusted so the walker is level.
Wheel
Front
Back
Walker
Frame
Snap
Button
Locknut
Washers
Leg Tube
Hex
Screw
Bushing
DETAIL “B” - MODEL NOS.
6273 AND 6267
DETAIL “C” - MODEL NO. 6275
Adjustment
Holes
Swivel Wheel
Attachment
Leg
Extension
NOTE: Model no. 6372 has dual wheels on
the right and left front legs.
the right and left front legs.
DETAIL “A” - MODEL NOS. 6270, 6271,
AND 6372
Adjustment
Holes