Invacare TDX SI Manual Do Utilizador
SECTION 10—BATTERIES
57
Removing the Batteries from Wheelchair
NOTE: For this procedure, refer to FIGURE 10.3.
1. Slide battery tray with batteries out.
2. Disconnect the battery straps.
3. Unplug front battery from rear battery.
4. Remove the front battery.
5. Slide the rear battery forward and remove it from the tray.
FIGURE 10.3 Removing the Batteries from Wheelchair
Installing Batteries into Wheelchair
NOTE: For this procedure, refer to FIGURE 10.3 and FIGURE 10.4 on page 58.
NOTE: Positioning of the batteries into the battery tray is completed with battery tray positioned
in wheelchair and partially pulled out. Refer to FIGURE 10.3 for full view of wheelchair base.
Illustrations in FIGURE 10.4 on page 58 are shown without the wheelchair for clarification
purposes only.
in wheelchair and partially pulled out. Refer to FIGURE 10.3 for full view of wheelchair base.
Illustrations in FIGURE 10.4 on page 58 are shown without the wheelchair for clarification
purposes only.
1. Position the battery with battery connector bracket in the rear of the battery tray in the
orientation as shown. See Detail “A” of FIGURE 10.4 on page 58.
NOTE: Front of battery tray is designated by the battery stop. Rear of the battery tray is the
opposite end.
opposite end.
NOTE: Orientation of the battery is critical otherwise batteries will not connect to the controller
or each other.
or each other.
2. Position the remaining battery in the front of the battery tray in the orientation shown
so that the wiring harnesses can be connected together. See Detail “B” of FIGURE 10.4
on page 58.
on page 58.
3. Connect front battery to rear battery. See Detail “B” of FIGURE 10.4 on page 58.
4. Connect battery straps. See Detail “C” of FIGURE 10.4 on page 58.
Disconnect Front Battery
from Rear Battery Here
FRONT OF WHEELCHAIR
Rear Battery
Front Battery
Battery Straps
Battery Tray