Invacare RPA450-1 Folheto

PADDED ACTUATOR COVER
PART NO. 1083039

Assembly, Installation and Operating Instructions

OVER

INSTALLING/REMOVING THE
ACTUATOR COVER (FIGURE 1)

1. Lock the casters as shown in DETAIL "A".

2. Remove the metal ring attached to the RED emergency

release pin as shown in DETAIL "D".

3. Lift-up on the boom and place it on your shoulder.

4. Remove the nut, bolt and washer securing the actuator

shaft extension to the boom mounting bracket.

5. Remove the pinch guard and bushing from the actuator

shaft extension.

6. Let the actuator rest on your chest.

7. Perform one (1) of the following:

A. Install the actuator cover by sliding the large opening of

the padded actuator cover over the actuator assembly.

NOTE: Ensure large opening is pulled all the way
down, with elastic band under actuator base. Ensure
RED emergency release pin protrudes through small
hole in actuator cover as shown in DETAIL "B".

B. Remove the actuator cover.

8. Rotate the actuator shaft extension until it lines-up with the

holes in the boom mounting bracket.

FIGURE 1 - INSTALLING/REMOVING THE ACTUATOR COVER

Nut

DETAIL "C"

STEPS 4, 5, 8 -11

Boom Mounting Bracket

Actuator Shaft Extension

Pinch Guard

Bolt

Washers

Bushing

NOTE: Check all parts for shipping damage. In case of dam-
age, DO NOT use. Contact your Dealer for further instruction.

SAFETY SUMMARY

The following recommendations are made for the safe
use of the PADDED ACTUATOR COVER:

GENERAL WARNINGS

The Padded Actuator Cover is for use ONLY on
the following lifts: RPA 450-1, RPL 450-1 and RPA
600-1.

DO NOT install or use this equipment without first
reading and understanding these instructions. If
you are unable to understand the Warnings, Cau-
tions or Instructions, contact a healthcare profes-
sional, dealer or technical personnel before at-
tempting to install this equipment - otherwise, in-
jury or damage may occur.

After ANY adjustments, repair or service and
BEFORE use, make sure all attaching hardware
is tightened securely - otherwise injury or dam-
age may occur.

INSTALLATION WARNING

Caster locks MUST be locked during this pro-
cedure to prevent injury or damage.

CAUTION

DO NOT tumble dry the actuator cover.

Boom

(STEP 3)

Actuator

(STEP 6)

Step Here

to Lock

Step Here

to Unlock

Locking

Lever

DETAIL "A"

STEPS 1 AND 13

Metal Ring

RED Emergency

Release Pin

DETAIL "B"

STEP 7

Actuator

Cover

Actuator

Base

DETAIL "D"

STEPS 2 AND 12

Red Emergency

Release Pin

FRONT

BACK