Invacare 1048919 Folheto
1
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
Back Cane Replacement Kits
for 9000 Series Wheelchairs
for 9000 Series Wheelchairs
Kit Nos. 1048919, 1048920, 1048921, and 1048922
NOTE: These instructions apply to the 9000 XT/XDT and the 9000 SL with adjustable
back angle option.
back angle option.
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact
Carrier/Invacare for further instructions.
Carrier/Invacare for further instructions.
Safety Summary
WARNING
DO NOT install this equipment without first reading and understanding this
instruction sheet. If you are unable to understand the warnings, cautions and
instructions, contact a healthcare professional, dealer or technical personnel
if applicable, before attempting to install this equipment - otherwise, injury or
damage may occur.
Invacare products are specifically designed and manufactured for use in
Invacare products are specifically designed and manufactured for use in
conjunction with Invacare accessories. Accessories designed by other
manufacturers have not been tested by Invacare and are not recommended
for use with Invacare products.
After ANY adjustments, repair or service and BEFORE use, make sure that
After ANY adjustments, repair or service and BEFORE use, make sure that
all attaching component parts are secure.
NOTE: For this procedure, refer to FIGURE 1.
1. Remove the two mounting screws and washers that secure the back upholstery
to the back canes (Detail “A”).
2. Remove the two mounting screws, locknuts, and (for wheelchairs
manufactured after 11/1/2005) spacers that secure one back cane to the
wheelchair frame (Detail “C”).
wheelchair frame (Detail “C”).
3. Pull the loose back cane out of the back upholstery.
4. Slide a new back cane through the back upholstery.
5. Secure the new back cane to the wheelchair frame at the desired back height
with the two mounting screws, locknuts, and (for wheelchairs manufactured
after 11/1/2005) spacers (Detail “B”).
after 11/1/2005) spacers (Detail “B”).
NOTE: For wheelchairs manufactured after 11/1/2005, the spacers must be on the outside
of the wheelchair in order for the mounting screws to be properly tightened (Detail “C”).
of the wheelchair in order for the mounting screws to be properly tightened (Detail “C”).
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS