Shoprider JIFFY11 UL7WR11 Manual Do Utilizador

 

4/27/2006 

20

 
Battery Charging Procedure 
Charging the Shoprider compact Powerchair: 
     
          Smartie, Jiffy & Jiffy11 
 

1) Plug the A/C power cord into the wall. Plug the male three-pin 

charger plug into the female 3-pin receiver located on the 
bottom of the VSI (Refer to Figure 3, #8). Note: the Jiffy & 
Jiffy11 battery pack must be turned on to accept charge. 

 

2) Remove the battery-pack from the unit. Plug the A/C power 

cord into the wall. Located on the battery-pack is a charger port. 
Slide the charger port cover over to expose the charger female 
3-pin receiver. Plug the male three-pin charger plug into the 
female 3-pin receiver. It is not necessary for the battery-pack to 
be attached to the Powerchair to charge. 

 
The battery charger’s light indicator is as follows: 
Red    - 

Charging 

Green - 

Charging complete 

Depending on the amount of battery discharge, the charge time can 
take up to 12 hours (Jiffy/Jiffy11 Only). The battery charger has an 
electronic switch that will terminate the charge when the batteries are 
fully charged. Do not remove the battery charger until the charging 
cycle is complete. Be sure to unplug charger from the wall first before 
unplugging charger from the Powerchair & turn battery pack off 
(Jiffy/Jiffy11 only). 
WARNING! Only use the original manufacturer approved 
charger! 
This charger is for indoor use only. Do not expose it to rain or 
water spray. 
Do not leave the charger plugged into the Charging Port if the 
charger is not charging.