Shoprider TE-787M Manual Do Utilizador
8/12/2004
14
BATTERIES AND BATTERY CHARGING
The Shoprider® Scootie Jr. Portable scooter is supplied with maintenance-free, sealed lead
acid batteries. For easy handling, the batteries are contained within a battery pack. Battery
life and performance may be affected by temperature, terrain, condition of battery, the
weight of the user, and care of batteries. The battery needle gauge is only a guide and is
most effective when the scooter is moving, only then is the true discharge level displayed.
• When the scooter stops the battery needle gauge may indicate full.
• An active user can use up to 30% of battery capacity or more per day.
• Inactive users may only use 50% of battery capacity in a week.
• In both these instances the battery should be put on charge over night.
Keeping the batteries charged will extend the life of the batteries
Battery Charger
The battery charger is a 2-amp transformer type off board. The Scootie Jr. Portable scooter
has a built in charger port on the side of the battery pack. This special feature allows the
batteries within the battery pack to be charged without the scooter.
First Time Use
Prior to using your Scootie Jr. Portable scooter for the first time, you must charge the
batteries fully (refer to Battery Charging Procedures). Charging may take up to 12 hours.
Charging the batteries completely prior to first time use will benefit battery efficiency.
Failure to do so may cause damage.
Charging
To charge the batteries connect the 3-pin male plug lead into the 3-pin female battery-
charging socket on the battery pack. Plug the A/C cord plug into the wall socket and the
other end into the charger (2-pin). The battery charger has two indicator lights. The red light
shows the batteries are charging. When the light turns green while connected to the
charging port the batteries are fully charged. Once the batteries are completely charged,
unplug the A/C cord from the wall then unplug the 3-pin lead from the battery pack.
WARNING: Only use the original Shoprider approved charger!
This charger is for indoor use only. DO NOT expose it to rain or water spray.
Do not leave the charger plugged into the charger port if the charger is not charging.
Keeping the batteries charged will extend the life of the batteries
Battery Charger
The battery charger is a 2-amp transformer type off board. The Scootie Jr. Portable scooter
has a built in charger port on the side of the battery pack. This special feature allows the
batteries within the battery pack to be charged without the scooter.
First Time Use
Prior to using your Scootie Jr. Portable scooter for the first time, you must charge the
batteries fully (refer to Battery Charging Procedures). Charging may take up to 12 hours.
Charging the batteries completely prior to first time use will benefit battery efficiency.
Failure to do so may cause damage.
Charging
To charge the batteries connect the 3-pin male plug lead into the 3-pin female battery-
charging socket on the battery pack. Plug the A/C cord plug into the wall socket and the
other end into the charger (2-pin). The battery charger has two indicator lights. The red light
shows the batteries are charging. When the light turns green while connected to the
charging port the batteries are fully charged. Once the batteries are completely charged,
unplug the A/C cord from the wall then unplug the 3-pin lead from the battery pack.
WARNING: Only use the original Shoprider approved charger!
This charger is for indoor use only. DO NOT expose it to rain or water spray.
Do not leave the charger plugged into the charger port if the charger is not charging.