Manual Do Utilizadoríndice analíticoStorage/Control I/O Module1Specifications1Description2Front Panel Indicators and Ports Assignments2Figure4-1 Storage/Control I/O Module Front Panel3:4Hard Disk Drive4Figure4-2 Location of the Hard Disk Drive on the Storage/Control I/O Module5Figure4-3 Location of Hard Disk Drive LED on the Combined Controller6Midplane Connectors6Figure4-4 Control Midplane7Serial Ports 1 and 27Table4-1 Serial Ports 1 and 2 Pin and Signal Assignments7Figure4-5 I/O Module to Master Console—Cable Wiring Diagram8Figure4-6 I/O Module to Remote Maintenance Modem—Cable Wiring Diagram8Serial Ports 3 and 49Table4-2 Serial Ports 3 and 4 Pin and Signal Assignments9Ethernet Interface9Table4-3 Ethernet Port Pin and Signal Assignments10Printer Interface10Figure4-7 I/O Module to System Printer—Cable Wiring Diagram10SCSI Interface11Hardware Configuration11SCSI Termination Configuration11Serial Port Configuration11Serial Ports 1 Through 4 and Jumper Settings11Serial Ports 1 Through 412Table4-4 Jumper Positions for DCE and DTE Modem Connections12Figure4-8 Jumper Locations on the Storage/Control I/O Module Card12Figure4-9 Jumper Configuration for DCE/DTE, Serial Ports 1-413Figure4-10 Jumper 15 Configuration of Clock Lines, Serial Port 413Removal and Replacement Information13Figure4-11 Storage/Control I/O Module Location14Removal Procedures15Step 1 Remove the Combined Controller that is connected to the Storage/Control I/O Module to be s...15Step 2 Use a 1/8-inch bladed screwdriver to loosen the captive mounting screws at the top and bot...15Step 3 Grasp the screws at the top and bottom of the card and pull the card away from the midplane.15Step 4 When the card is free of the connector, grasp the sides of the front panel and pull the ca...15Step 5 Grasp the card on its bottom edge as it is removed from the card rack.15Step 6 When you have removed the card from the slot, place it on an antistatic mat or in an antis...15Step 1 If servicing an active Storage/Control I/O Module, switch the active side to standby. Refe...15Step 2 When the transition to standby is complete, remove and replace the Storage/Control I/O Mod...15Replacement Procedures16Step 1 Place the replacement Storage/Control I/O Module on the antistatic mat or envelope.16Step 2 Verify that the Combined Controller that is to be connected to the Storage/Control I/O Mod...16Step 3 Verify that all the jumpers on the replacement card correspond with those on the removed S...16Step 4 Grasp the replacement card by the sides of the front panel and align it with the top and b...16Step 5 Push the card inward until it makes contact with the midplane.16Step 6 Firmly push the card toward the midplane. The card fits tightly into the midplane connecto...16Step 7 Use a 1/8-inch bladed screwdriver to tighten the mounting screws at the top and bottom of ...16Step 8 Plug the Combined Controller into the backplane.16Step 9 If installing in a nonredundant system, make sure the system is powered on.16Step 10 If the hard disk drive does not contain the Generic software, install the software. Refer...16Troubleshooting16LEDs Not Illuminated16Troubleshooting Reference Materials17Tamanho: 2 MBPáginas: 18Language: EnglishAbrir o manual
