Manual Do Utilizadoríndice analíticoWT4911 Two-Way Wireless Outdoor Siren1Installation Instructions1Specifications1Two-Way Wireless Outdoor Siren Enrollment1Quick Enrollment11. Enter the enrollment mode through installer programming, see section [898].12. Power up the outdoor siren by activating the pre-installed battery (plug the battery cable into the battery connector located inside the backplate to activate the battery.) If it is already powered up, press and release the tamper switch.13. The outdoor siren sends a request to the security panel to enroll on the system.14. The keypad displays the electronic serial number which must be confirmed by keying in [*]. If the electronic serial number is incorrect, Press [#] and repeat this step.15. Select the module number that the device should be enrolled as.16. Repeat starting from step 2. to enroll each additional outdoor siren.11. Enter the enrollment mode through installer programming, see section [804].12. Select the module number that the device will be enrolled as. Sections [301]-[304] for sirens.13. Enter the serial number using the keypad.1Placement Test11. Place the security panel into placement test, see section [906].12. Start the placement test by tampering the outdoor siren being tested.13. The siren will respond with 1 strobe flash and 1 beep if the location is “Good”. If the siren is at a “Bad” location then it will respond with 3 strobe flashes and 3 beeps.1Physical Installation11. Open the WT4911 by lifting the front cover up from the siren bottom until it separates from the backplate.12. If the battery is not already activated, plug the battery cable into the battery connector, see figure 2.13. Position the backplate on a flat mounting surface and mark this location.14. Secure the backplate to the mounting surface with all the screws provided for this purpose (4 screws). A screw must be installed in the tamper switch portion of the backplate.15. Carefully hinge then snap the front cover back onto the backplate, making sure it is correctly aligned, see figure 1.16. Secure the front cover to the backplate with 2 front cover screws. The remaining screws are spares.1Battery Replacement1Configuration and Testing1Tamanho: 600 KBPáginas: 2Language: EnglishAbrir o manual
