Manual Do Utilizadoríndice analíticoMaster TOC6Safety2Section A Installation7Section B Operation15Section C Accessories25Section D Maintenance27Section E Theory of Operation33Section F Troubleshooting & Repair41Symptoms48Major Physical or Electrical Damage is Evident44No LEDs light when the ON/OFF Power Switch is turned "ON". Machine is dead. Fan is not running.44No LEDs light when the ON/OFF Power Switch is turned "ON". Machine is dead. Fan runs normally.45The "MACHINE ON" LED is lit and the "SAFETY" LED is lit.45The air begins to flow, the "OUTPUT ON" LED lights for a short time, but no pilot arc is established. The high frequency arc ...46The air begins to flow, the "OUTPUT ON" LED lights for a short time, but no pilot arc is established.47The "THERMAL" LED is lit. The "MALFUNCTION" or "FAULT" LED is blinking. The machine has no output.48The "MALFUNCTION" or "FAULT" LED is lit. The machine has no output.48When the torch trigger is pulled the "OUTPUT ON" LED lights for a very short period of time. The pilot arc is unusually bright.48The "OUTPUT ON" and "MALFUNCTION" or "FAULT" LED's blink in alternating order. No pilot arc.49Airflow does not shut off.50The "OUTPUT ON" and "AIR PRESSURE" LED's blink in alternating order.50The "MACHINE ON" LED is lit but there is no response when the torch trigger is pulled. The "AIR PRESSURE" LED does51The arc starts but sputters badly. (If cutting expanded metal, condition may be normal, see operation section.)52The "MALFUNCTION" or "FAULT" LED starts blinking during cutting or gouging.52Pilot arc is OK but cutting arc will not establish.52Section G Electrical Diagrams95Tamanho: 2 MBPáginas: 114Language: EnglishAbrir o manual