Manual Do Utilizadoríndice analíticoMaster TOC6Safety2Section A Installation7Section B Operation15Section C Accessories31Section D Maintenance40Section E Theory of Operation50Section F Troubleshooting & Repair55Symptoms58Major physical or electrical damage is evident.58No weld output and no auxiliary power. Engine operates normally.58No weld output, the auxiliary power (230-115VAC) is operating normally. Engine operates normally.59No auxiliary power at receptacles welding output is normal – engine runs normally.60Machine has low welding output and low auxiliary output.61No DC welding output. AC welding output and auxiliary power are normal.62No AC welding output. DC welding output and auxiliary power are normal.62No constant voltage (CV) welding output. Constant current (CC) and the auxiliary power are operating normally.63The constant voltage (CV) welding output is low or unstable. Constant current (CC) and auxiliary power are operating normally.63Engine will not idle down to low speed. Machine has normal weld output and auxiliary power.64Engine will not go to high idle when attempting to weld. Welding output is normal when Idler switch is..65The engine will not go to high idle when attempting to weld or when the auxiliary power is loaded.66The engine will not crank or cranks very slowly.66The engine cranks but will not start.67The engine goes to low idle but does not stay in low idle.68Output control on welder not functioning.69Remote output control not functioning.69The wire feeder does not work when connected to the welder amphenol.70The CV output contactor does not pull in when using a wire feeder with a control cable connected to the RANGER 10-LX amphenol.71The CV output contactor does not pull in when the wire feeder switch (S8) is in the NO CONTROL CABLE position.72The CV output contactor does not deactivate (drop out) when a wire feeder with a control cable is connected ...72The CV output contactor does not deactivate (drop out) when a wire feeder without a control cable is ...73The battery does not stay charged.73The welding arc is “cold.” The engine runs normally (3700 RPM no load). The auxiliary power is functioning normally.74Section G Electrical Diagrams125Tamanho: 2 MBPáginas: 133Language: EnglishAbrir o manual