Manual Do Utilizadoríndice analíticoMaster Table of Contents5Safety Section2Section A - Installation7Section B - Operation13Section C - Accessories21Section D - Maintenance23Section E - Theory of Operation27Section F - Troubleshooting and Repair35Symptoms38Machine is dead - no output - no fan - no status indicator lights.38Major physical or electrical damage38Machine is malfunctioning - no38The machine powers up properly, and cuts OK with 230 input applied. With 115 applied the pilot arc ignites but goes out when cutting commences. Or, no pilot or cutting when 115 input is supplied.39The machine powers up properly, but there is no response (no air flow or pilot arc) when the torch trigger is pulled. Only the power LED is lit.39The machine powers up properly, but only air flows when the torch trigger is pulled; no pilot arc is established.39The air begins to flow when the torch trigger is pulled. There is a very brief pilot arc. (Normal is 3 Seconds.) The sequence is repeated with subsequent trigger pulls.39The cutting arc starts but sputters badly.40The pilot arc is normal, but the arc will not transfer to the work piece.40Trigger or purge is activated brief air flow then the safety light illuminates.40Poor performance of pilot arc or cutting. Poor consumable life.40Will only cut thin gauge material or cutting cutting is 1/2 of what it should be. Cuts for 3 seconds then quits.41When nothing is described for your problem, or you have performed your test with no solution.41The Thermal LED is lit after normal use.42Section G - Electrical Diagrams83Tamanho: 2 MBPáginas: 92Language: EnglishAbrir o manual