Manuais de utilizador para VXi TECHNOLOGY SVM2608

índice analítico

• Preface

  1
  • Table of Contents

    3
  • Certification

    5
  • Warranty

    5
  • Limitation of Warranty

    5
  • Restricted Rights Legend

    5
  • Declaration of Conformity

    6
  • General Safety Instructions

    7
  • Support Resources

    9
• Section 1

  11
  • Introduction

    11
    • Introduction

      11
    • Overview

      11
      • Acquiring Data

        13
      • Triggering

        13
      • Linear Mode

        14
      • Pre-Trigger

        14
      • Delayed Trigger

        14
      • FIFO Mode

        15
      • Calibrations

        15
      • Test Bus

        15
      • Commands

        15
      • Option -01

        16
    • Physical Description

      18
    • Front Panel Interface Wiring

      19
    • SVM2608 Specifications

      20
• Section 2

  23
  • Preparation for Use

    23
    • Introduction

      23
    • Calculating System Power and Cooling Requirements

      23
    • Setting the Chassis Backplane Jumpers

      23
    • Setting the Base Address

      24
    • Module Installation/Removal

      26
• Section 3

  27
  • Programming

    27
    • Introduction

      27
    • Device Memory Maps

      27
      • Function Offset

        27
      • Register Offset

        27
    • Data(Byte) Ordering

      30
    • Determining the Register Address

      31
    • Accessing the Registers

      32
    • Description of Registers

      32
    • Microprocessor Commands

      41
      • Measurement Commands

        41
      • Captured Data Calculations

        42
      • Resistance Measurement – Offset Method

        43
      • Resistance Measurement – Dynamic Method

        43
      • Self Test Command

        43
      • Preset Setting Measurement Commands

        44
      • Calibration Commands

        45
      • Error Processing

        47
      • Diagnostic Commands

        49
    • Examples

      51
      • Example 1: Setting the Channel 2 and 4 Sample Rate to 123 ms (8.13 kHz)

        51
      • Example 2: Setting Channel 2 to Acquire 200,000 Samples

        51
      • Example 3: Setting Channel 2 to Pre-acquire 100,000 Samples

        52
      • Example 4: Setting Channel 2 to Delay Acquisition by 1,500,000 Samples

        52
      • Example 5: Setting Channel 2 and 4 Timeout Register to Timeout after 2.5 s

        53
• Appendix A

  55
  • Appendix A

    55
    • Data Swapping Example

      55
• Index

  57