Справочник Пользователя для Land Pride rcf3696
27
Section 1: Assembly & Set-Up
12/15/15
RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M
3.
Check driveline for adequate clearance under all
ranges of cutter height.
ranges of cutter height.
a. With driveline attached to tractor and cutter,
slowly raise and lower cutter to its upper and
lower limits while observing clearances between
hitch and driveline.
lower limits while observing clearances between
hitch and driveline.
b. Adjust tractor drawbar height and/or length if
driveline interferes. See Figure 1-1 on page 10 for
correct drawbar dimensions.
correct drawbar dimensions.
4.
Cycle hydraulic system by extending and retracting
lift cylinder several times. It may be necessary to
purge hydraulic system of trapped air if operation is
sluggish. Refer to “Purge Hydraulic System” on this
page.
lift cylinder several times. It may be necessary to
purge hydraulic system of trapped air if operation is
sluggish. Refer to “Purge Hydraulic System” on this
page.
Purge Hydraulic System
!
DANGER
1.
With deck skid shoes resting firmly on the ground,
shut tractor off, and move hydraulic control lever back
and forth to relieve all hydraulic pressure in the
hydraulic system.
shut tractor off, and move hydraulic control lever back
and forth to relieve all hydraulic pressure in the
hydraulic system.
2.
Loosen hydraulic hose fitting at the hydraulic cylinder
slightly to allow air and fluid to escape.
slightly to allow air and fluid to escape.
3.
Restart tractor and slowly activate tractor control
lever to extend hydraulic cylinder to purge trapped air
from the hydraulic system.
lever to extend hydraulic cylinder to purge trapped air
from the hydraulic system.
4.
After all air is purged from the hydraulic system and
all hydraulic pressure is relieved, retighten hose
fitting at the hydraulic cylinder.
all hydraulic pressure is relieved, retighten hose
fitting at the hydraulic cylinder.
Pull-Type Tractor Hook-Up
Figure 1-24
33951
Tractor Drawbar
Storage Location
For Parking jack (#10)
For Parking jack (#10)