Листовка для Extron electronic RM 700M

Extron 

USA - West 

Headquarters

Inside USA / Canada Only

+1.714.491.1517 FAX

Extron 

Inside USA / Canada Only

+1.919.863.1797 FAX

Extron 

Inside Europe Only

+31.33.453.4050 FAX

Extron 

Inside Asia Only

+65.6383.4664 FAX

Extron 

+81.3.3511.7656 FAX

Extron 

Inside China Only

+86.21.3760.1566 FAX

Extron 

+971.4.2991880 FAX

© 2009  Extron Electronics.  All rights reserved.

The Extron

®

 RM 700M allows the TLP 700MV TouchLink

™

 panel to 

be mounted in a standard rack.  The RM 700M uses 5 U of vertical  

space in a standard 19 inch equipment rack.
This guide provides basic instructions for an experienced installer 
to mount and connect the TLP 700MV.

To mount the TLP 700MV in any standard 19" equipment rack, follow these instructions:
1.

  Disconnect all cables from the TLP 700MV.

  Run cables for video, network and power to the rack.

  Secure the RM 700M to the rack, using 

the screws provided by the rack's 

manufacturer.

  Remove the faceplate from the 

TLP 700MV and ensure 

that all the locking 

arms are laying 

flush with the unit.

  Push the 

TLP 700MV 

through the hole 

in the mounting 

kit and tighten the 

six screws for the 

locking arm.  As 

the screws tighten, 

the locking arms 

rotate and clamp 

against the back 

of the mounting 

kit, holding the 

TLP 700MV in place.

  Connect the cables to the rear panel connectors.

 

Connect the LAN port to the network with a 

straight-through cable.

 

Connect an S-video or composite video source to 

the unit, using these two BNC connectors:

For S-video, connect the Y (luminance) signal 

•

to the VID/Y input and the C (chrominance) 

signal to the C input.
For composite video, connect the input to the 

•

VID/Y input.

 

Connect the power input to a 12 VDC, 1.0 A 

power supply, using the 2-pole captive screw 

connector.

7.  If you do not plan to calibrate the TLP 700MV immediately (see the TLP 700MV user's manual), replace the 

faceplate by pressing the catches on the faceplate into the corresponding holes on the sides of the panel.

68-1793-01

Rev. A 08 09

Tighten screws to
rotate locking arms.

Secure RM 700M to rack.

Screws (6) Provided
by Manufacturer

Faceplate snaps to unit.
(4 plcs ea side)

RM 700M

Power input

Video inputs (2)

LAN input

TLP 700MV Rear Panel