Справочник Пользователя для Brother 888-X54

—

CAUTION

Hold the needle with your left hand, and
then use a screwdriver to turn the needle
clamp screw counterclockwise to remove
the needle.

1 Use a screwdriver

• Do not use excessive force when loosening

or tightening the needle clamp screw,
otherwise certain parts of the sewing
machine may be damaged.

With the flat side of the needle toward the
back of the machine, insert the needle
until it touches the needle stopper. Next,
tighten the needle clamp using a
screwdriver.

CAUTION

Changing the presser foot

CAUTION

You will have to change the presser foot depending on
what you want to sew and how.

Turn off the machine.
Raise the presser foot lever.

Raise the needle by turning the
handwheel toward you
(counterclockwise) so that the mark on
the wheel points up.

Remove the presser foot by pulling it
vertically downward.

Put a different presser foot on the needle
plate so that the bar on the presser foot is
in line with the slot on the shank.

●

Before replacing the needle, place fabric
or paper under the presser foot to
prevent the needle from falling into the
hole in the needle plate.

1 Use a screwdriver
2 Needle stopper
3 Needle

●

Make sure you insert the needle until it
touches the stopper, and securely tighten
the needle clamp screw with a
screwdriver, otherwise the needle may
break or the machine may be damaged.

●

Always turn off the machine before you
change the presser foot. If you leave the
power on and step on the controller, the
machine will start and you may be
injured.

●

Always use the correct presser foot for
the stitch pattern you have chosen. If
you use the wrong presser foot, the
needle may strike the presser foot and
bend or break, and may cause injury.

●

Only use presser feet that have been
designed to be used with this machine.
Using any other presser foot may cause
accident or injury.

1 Presser foot holder
2 Presser foot