Справочник Пользователя для Pelco C2908M-B

C2908M-B (4/05)

49

4. On the PelcoNet NET300 Setup Page (Figure 22), select Interface Settings COM1. Use the pull-down menu to set the serial data port to 

Transparent. Also set the baud rate for the connected external device you want to control.

5. Finally, from the Device Controls page (Figure 36), select Keyboard. This takes you to the “Keyboard Control with live video” page 

(Figure 41). The COM port is open and you can send transparent data from your PC COM port to the PelcoNet COM port, and vice versa.

Network and routing information make up the configuration page for network settings. These settings are used to integrate the NET300 into an 
existing network. The table that follows describes the configuration items.

Figure 33.  Configuration Page for Network Settings (Transmitter Shown)