Справочник Пользователя для Heath Zenith 598-1119-07

© 2007 HeathCo LLC 

598-1119-07

•  Quickly add ON/OFF control of a receptacle without the expense of new wiring.
•  Four selectable channels allowing the use of up to four separate systems in the same home.
•  Products are UL/cUL and/or FCC/IC tested and approved.
•  Operational range of up to 50 feet.

1.   The two buttons on the remote will 

operate one or more receiver units 
with matching channels.

 

Note: Receivers must be at least 10 
feet apart for best performance. 

2.  Push  the  ON  button  to  turn  the 

plugged  in  receiver  on  or  the 
OFF button to turn the plugged in 
receiver off.

The remote control requires a type A23 12 Volt 
alkaline battery to operate. The remote control 
is shipped with the battery installed. With typical 
use, the battery will last approximately one year. 
Remove battery when remote will not be used 
for an extended period of time.
To  replace  the  battery,  follow  the  instructions 
below:
1.  Place  remote  control  face  down  on  a  flat 

surface.

2.  Remove screw on bottom of remote with a 

small phillips-head screwdriver.

3.  Gently insert a small flat-head screwdriver 

between the two halves on the bottom of the 
remote and twist. Carefully separate the back 
of the remote from the front.

4.  Lift the back of the remote up and lay aside.
5.  Remove battery. Install replacement battery. 

Make sure battery is oriented properly (see 
illustration).

6.  Reassemble remote in reverse order.

ON

12 V

1 2

Battery

Compartment 

(Type A23)

Flat-Head 

Screwdriver

Philips-Head 

Screw

Remote

Control Back

This manual applies to the following products: